A Guide to Kitchen Sink Installation

Did you know that the original sink was just a huge boulder worn by ages of rain into a concave form?

It was not until families had rooms dedicated as kitchens that improvements in sink units occurred. 

When you think of your dream kitchen, things that spring to mind are flowing countertops and under-counter appliances—everything except the kitchen sink and kitchen sink installation. Yes, the basic sink is an often-overlooked improvement that makes a big difference in your everyday kitchen activity.

The installation of a kitchen sink is a service that the majority of homes need. Read our guide to learn about kitchen sink installation.

Is It Easy to Replace a Kitchen Sink?

Although it may seem daunting, installing a kitchen sink is a straightforward procedure. It does not matter whether you’ve ever worked with plumbing before or not.

Many variables, including the sink’s weight and size, are determined by the simplicity with which a sink is installed. Even if you intend to do the job alone, you may need a helping hand lifting the sink into position.

That being said, there is always the possibility of something going wrong. In that case, it may be wise to reach out to a plumbing and drain service provider like the one at plumbtimesc.com

What’s Needed for Kitchen Sink Installation?

To install a kitchen sink, you do not need many tools. However, here are some of the things to get together before you start the job:

  • An adjustable pipe wrench
  • A socket wrench
  • A putty knife
  • A knife
  • Plumber’s putty
  • Silicone caulk

It is a certainty that there will be water spillage at some stage. Because of this, make sure you gather plenty of towels and a small bucket nearby.

Steps for Sink Installation

The instructions below will assist you in installing your new sink. But, first, make sure you have all the above materials together.

Disconnect the Plumbing Under the Sink

Before you begin disconnecting your under-sink plumbing, ensure that the water supply to the sink is turned off. If there are no cutoff valves under your sink, you will have to turn off the water to the whole home. Once you’ve done that, turn on your tap to empty the mainline and relieve any residual pressure.

Disconnect the source and drain lines now. To be safe, have a bucket close by to collect any leaking water. 

Remove the Old Sink

Use your knife to clean the caulk that is around your old sink. After doing so, unscrew the screws holding the sink in place under the counter. 

You should now be able to push the sink upwards from underneath to loosen it. Remove the old sink.

Installing the New Sink

Double-check to see if the new sink will fit by placing your sink over the hole. Attach the clips to the sink’s edge. Seal the edges of your strainer with the plumber’s putty. Position the strainer with the putty side down.

Finally, put rubber seals around the sink’s drain. It’s now time to relocate your sink. Finally, swivel the clips to secure the sink in place. Next, apply silicone caulk around the sink edge, and then wipe away any spillage using a damp paper towel.

Got That Sinking Feeling? Install a New One

As we have shown, kitchen sink installation is an incredibly feasible do-it-yourself job. However, having said that, it may rapidly morph from feasible to intimidating. If such is the case, it is advisable to contact a professional in circumstances like these.

If you have found this article helpful, why not browse our website for more interesting articles on life!

By Malik

error: Content is protected !! Try on Someone Else LOL